Mode Accessing Path Prompt Logout or Access the next mode User EXEC Mode Primary mode once it is connected with the swi tch.Ħ 2.
T ype the User name and Passwo rd (the factory default value fo r both of them is admin) and press the Enter button, then you can use the CLI now, which is shown as Figure1-4.ĥ The following table gives detailed information about the Accessing path, Prompt of each mode and how to exit the current mode and access the next mode. T ype telnet 192.168.0.1 in the command prompt shown as Figure 1-3, and press the Enter button. T o log on to the switch by a T elnet connection, please take the following steps: 1.Ĥ 4. Chapter 12: Ethernet Configuration Commands Provide information about the commands used for configuring the Bandwidth Control, Negotiation Mode, and S torm Control for enthernet ports.ģ Chapter 1 Using the CLI 1.1 Accessing the CLI Y ou can log on to the switch and access the CLI by logging on to the switch remotely by a T elnet through an Ethernet port. The four devices of TL-SG2216/TL-SG2424/TL-S G2424P/TL-SG2452 are sharing this Guide.Ģ IP, reboot and reset the switch, upgrade the sw itch system and comm ands used for device diagnose, including loopback test and cable test. The device mentioned in this Guide stands for TL-SG2216/TL-SG2424 /TL-SG2424P/TL-SG2452 Gigabit Smart Switch. ġ Preface This Guide is intended for network administrator to provide referenced information about CLI (Command Line Interface). 170 show lldp neighbor-infor mation inte rface. X show lldp local-inform ation inte rface. VII Chapter 1 8 DHCP Filteri ng Comma nds. Other brands and product names are trademarks or registered trademarks of t heir respective holders. is a registered trademark of TP-LINK TECHNOLOGIES CO., L TD. I COPYRIGHT & TRADEMARKS S pecifications are subject to change without notice.